1996 KENT KGS-63SD

Capacity
Table working area (width x length).... 11.81" x 25.59"
Longitudinal table travel:...................... 27.95"
Cross table travel:................................. 13.39"
Maximum table load (with chuck)......... 550 Lbs.
Maximum/Minimum distance betweek working
table and spindle center:.................... 21.25"/4.72"

Table Cross Feed
Longitudinal table speed:................. 8 to 100 F.P.M.
Cross feed handwheel is graduated in
increments of:.................................. .0001"
Automatic cross feed per stroke of table:.. .02" to .4"

Grinding Wheel
Standard wheel dimensions:............... 14" diameter
1.5"Max. Width

5" Bore
Spindle Speed:.................................... 1,740 R.P.M.

Downfeed
Automatic down feed increment:........ 0.0001" to .004"
Downfeed handwheel is graduated
in increments of:................................. .0001"
Downfeed travel per revolution of handwheel:... .02"

Approx. Machine Weight:............................. 4,000 Lbs.

Equipped with:
Automatic incremental downfeed of grinding wheelhead
driven by stepping motor with Programmable Logic
Controller (PLC) of all machine functions including:
-"Rough Downfeed" increment and number of passes
-"Fine Downfeed" increment and number of passes,
-"Sparkout" times,
- "Downfeed Mode", for control of incremental downfeed
with table at right end of stroke, left end of stroke, or
both left and right end of stroke,
-"Wheelhead Elevation & Position" for control of elevation
increment at completion of grinding job,
-"Jog" increment to allow the operator to select three
different jog rates of the grinding wheelhead,
- "Reset" to set the current position of the grinding wheel
as 0 point The PLC has a LED Display to show the
position of the grinding wheel in relation to the starting
point.
Selector switch for surface or plunge grinding modes
Selector switch for automatic incremental downfeed,
downward jogging, or power rapid elevation of grinding
wheelhead
Hydraulically actuated longitudinal feed
Electromechanically actuated cross feed
WALKER "HAGOU" Made in Holland
12" x 23-5/8" Fine Division Electro-Magnetic Chuck
with console mounted controls including:
variable magnetic strength,
magnetization/demagnetization mode
selector, and voltage gauge meter
Over-The-Wheel parallel dresser
External Hydraulic pump and tank
External coolant pump and tank
5 HP 3/60/230-460 volt spindle drive motor

Parts and service available from
Kent Industrial (USA) @ (714) 258-8526

** Like New" Condition & Appearance **
** Inspect Under Power in our
Harrison, N.J. Warehouse **