1994 GALLMEYER & LIV 253V

HYDRAULIC TABLE TRAVEL, LONGITUDINAL .............. 23-1/2"
HYDRAULIC TABLE TRAVEL, CROSS ..................... 6-3/4"
LONGITUDINAL TABLE SPEEDS ................... 1" - 75" IPM
AUTO CROSS FEED TO TABLE PER STROKE ......... 0.01" TO 1/2"
CONTINUOUS CROSS SPEED ........................... 120" IPM
VERTICAL MOVEMENT OF WHEELHEAD ........................ 19"
AUTO INCREMENTAL DOWNFEED PER TABLE PASS ..0.0001" TO .001"
GRINDING WHEEL SIZE ...................... 5" DIA. x 1.25"B
GRINDING WHEEL RPM .............................. 3,600 RPM
APPROXIMATE FLOOR SPACE ....................... 85"W X 57"D
APPROXIMATE WEIGHT .............................. 4,250 LBS

EQUIPPED WITH:
* VERTICAL SPINDLE MADE BY "GMN WHITNON", STYLE 442-1630-190
(S/N: 302408), 3 H.P. MOTOR/3/60/230-460 VOLT, AIR BEARING DESIGN. UNIT
USES A 5" CUP WHEEL QITH 1-1/4" BORE.
* AUTOMATIC INCREMENTAL DOWNFEED (INCLUDING SADDLE LOCK, ADJ. HEAD KICK-UP &
VARIABLE SPARK-OUT)
* AUTO TABLE LOAD/UNLOAD POSITION
* DUAL RANGE (COARSE & FINE) DOWNFEED SYSTEM. FINE FEED ACTIVATED BY
INSERTING A PIN IN ONE OF 10 SOCKETS RANGING FROM .001" TO .010" ABOVE ZERO
SET POINT (FEED CAN BE ADJUSTED FROM .0001" TO .010" AT EACH TABLE REVERSAL)
* HYDRAULIC LONGITUDINAL AND CROSS FEEDS
* SLOW SPEED TABLE CONTROL - 1" TO 75" IPM
* 6" X 18" PERMAMENT MAGNETIC CHUCK
* AUTOMATIC SLOW SPEED TABLE WITH SWITCH SELECTION FOR INITIATION AT EITHER
ZERO SET POSITION OR FROM .001" TO .010" ABOVE
* POWER ELEVATION OF THE WHEEL (RAPID POSITIONING)
* FACTORY EXTENDED COLUMN (3"), PROVIDING FOR INCREASED VERTICAL CAPACITY
* COOLANT SYSTEM W/TANK/PUMP/SPLASH GUARDS
* 1.5 HP 3/60/220-440 VOLT HYDRAULIC SYSTEM MOTOR

SPECIAL NOTE: ORIGINAL AQUISITION COST FOR THIS MACHINE AS DESCRIBED WAS
OVER $75,000 IN 1994

*** LIKE NEW CONDITION & APPEARANCE *** ** INSPECT UNDER POWER IN OUR
N.J. WAREHOUSE **